There are a couple of models which require slightly different fitting configuration to avoid the very busy area around the oil filter. Most models are straight forward. The 1KZTE and the LN172-5L-E may need a different fitting to make things easier. Oil Cooler Sandwich adaptor to suit 24mm Toyota filter comes with two steel AN10 fittings and plugs for the side ports. Sandwich can be supplied with barb fittings if required. The steel fittings are matched for perfect intrusion depth into the adaptor and installed in the sandwich. This is a high flow adaptor. The fittings use a 1/2NPT taper thread into the sandwich which gives a very secure connection no rubber seals to worry about – no aluminium fittings to shear off. The two side ports are 1/8NPT but can be supplied in other sizes. Allows installation of oil cooler while the oil filter stays in position on the engine. Adaptor is fully adjustable within 360 degrees. Side ports allow installation of pressure guage, bypass filter, temperature sender and other extras. It is essential to use an oil cooler which has an adequate flow rate if you want good oil supply to the engine. All oil to the engine flows through the oil cooler. Make sure the hose and fittings you use are sound and can not cause accidental oil loss. Ideally, you should fit a foolproof oil pressure loss alarm in diesels when you plumb oil outside the engine. We can supply one. Make sure the cooler and hose have tubing of at least 1/2 diameter capacity. There should be 1/2 capacity throughout the system if you want maximum flow rate. The best oil coolers are good quality copper tube construction. The item “24mm Oil Cooler Sandwich JACKMASTER Steel Fittings fits Toyota Landcruiser etc” is in sale since Monday, March 28, 2016. This item is in the category “Vehicle Parts & Accessories\Car & Truck Parts\Gauges\Other”. The seller is “jackmaster55″ and is located in Thomastown, Victoria. This item can be shipped worldwide.

• Brand: Jackmaster
• Manufacturer Part Number: Does Not Apply