6-Gauge Set, Blueline Dials, Polished SS Bezels, 0-90 Ohm Fuel Level. 3-3/8 Electric Programmable Speedometer, 0-160 MPH. 3-3/8 Tachometer, 0-10,000 RPM. 2-1/16 Oil Pressure, 0-100 PSI with Sender. 2-1/16 Water Temperature, 120-280F with Sender. 2-1/16 Fuel Level Empty-Full, 0-90 Ohm input range (other ranges are available, see below for details). We double check each gauge for correct operation before packing your order. This process includes putting signals to all gauges to verify correct operation. We verify no accessory items are missing (u-clamps, bulbs, senders etc). We photo document your order to ensure completeness. Gauges are made in Anaheim, CA USA. High-speed full sweep stepper motor speedometer and tachometer. Short sweep electric 2-1/16 gauges. Programmable speedo with one-step easy calibration and 2 Trip meters. Tachometer works with 0.5, 1, 2, 3, 4, 5, and 6 PPR signal inputs. Hi-def white through-the-dial LED lighting and glowing pointer for easy viewing at night. Are sending units included? The oil pressure and water temp sending units are included. The volts gauge does not require a sender. A fuel level sender is not included. We can supply most common fuel level gauge ranges (0-90, 73-10, 240-33, 20-150 etc). The electric speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions. Pulse range generated proportional to the vehicle speed. Signal with minimum 3V peak to peak signal – typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs. Output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm). If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender. See the “Accessories” section. The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer. The tachometer does not require a sender – you get the signal from the coil (-) or other tach signal source i. ECU or Tach output on HEI or ignition box. Standard terms and conditions apply to this item. See our terms and conditions here: Terms & Conditions. The item “C2 Blueline 6 Gauge Set, Stainless Steel Bezels, 0-90 Ohm Fuel, Cobalt Blue” is in sale since Tuesday, March 13, 2018. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Gauges\Gauge Sets & Dash Panels”. The seller is “y2llc” and is located in Trabuco Canyon, California. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Israel, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica.
- Surface Finish: Black
- Warranty: Yes
- Part Brand: Marshall Instruments
- Manufacturer Part Number: 2164SS
- Brand: Marshall Instruments